Battery
72 SEL-351P Quick-Start Installation and User's Guide (Portuguese)
battery test is successful. This load test failure condition can be routed
to an output contact if desired (see SEL-351P Manual Técnico).
Battery Load Test via Front Panel
Press the OUTROS pushbutton on the front panel of the SEL-351P. A
new screen appears, with “BTT” (battery test) as one of the choices.
With the secondary function arrow pushbuttons, move the underscore to
BTT. To test the battery, press the secondary function SELEÇÃO
pushbutton. The following are possible results:
1.
If the battery monitor/charger has a problem, the following message
is displayed:
Battery Charger
Board FAILED
The BATERIA PROBLEMA LED would already be illuminated for
this condition. The battery load test is not performed.
2.
If the battery is damaged or disconnected (it cannot charge or
discharge), the following message is displayed:
Battery failed or not present
The BATERIA PROBLEMA LED would already be illuminated for
this condition. The battery load test is not performed.
3.
If the battery is okay (it is charging or discharging), the battery load
test proceeds, and the following message is displayed:
Testing Battery
. . . . . OK/FAIL
The periods on the second line appear consecutively as each second
of the 5-second load test times by. At the end of the test, OK or
FAIL is displayed. If the battery fails the 1 Amp load test (same
criteria as described in the preceding Automatic Battery Load Test
subsection), the BATERIA PROBLEMA LED illuminates and stays
illuminated until the next battery load test is successful. This load
test failure condition can be routed to an output contact if desired
(see SEL-351P Manual Técnico).
Battery Load Test via Serial Port
Execute the BTT NOW command, and the following are possible
results:
1. If the battery monitor/charger has a problem, the following message
is displayed:
Battery Charger Board FAILED
To Next Page
Loading...