Schweitzer Engineering SEL-351P - DAT Command (View;Change Date); EVE Command (Event Reports); GRO Command (Display Active Setting Group Number)

10-18 Serial Port Communications and Commands Date Code 990215
SEL-351P Manual Técnico
There may be up to 255 records in the extended report. To limit the number of COMM records
displayed in the report to the 10 most recent records, type COMM 10 L <ENTER>. To select
lines 10 through 20 of the COMM records for display in the report, type COMM 10 20 L
<ENTER>. To reverse the order of the COMM records in the report, supply a range of row
numbers, with the larger number first, i.e., COMM 40 10 L <ENTER>. To display all the
COMM records that started on a particular day, supply that date as a parameter, i.e., COMM
2/8/98 L <ENTER>. To display all the COMM records that started between a range of dates,
supply both dates as parameters, i.e., COMM 2/21/98 2/7/98 L <ENTER>. Reversing the order
of the dates will reverse the order of the records in the report. To receive a summary report for a
subset of the records, use one of the above methods while omitting the L parameter.
To clear the COMM records, type COMM C <ENTER>. The prompting message “Are you sure
(Y/N) ?” is displayed. Typing N <ENTER> aborts the clearing operation with the message
“Canceled”. If both M
IRRORED B ITS channels are enabled, omitting the channel specifier in the
clear command will cause both channels to be cleared.
DAT Command (View/Change Date)
DAT displays the date stored by the internal calendar/clock. If the date format setting DATE_F
is set to MDY, the date is displayed as month/day/year. If the date format setting DATE_F is set
to YMD, the date is displayed as year/month/day.
To set the date, type DATE mm/dd/yy <ENTER> if the DATE_F setting is MDY. If the
DATE_F is set to YMD, enter DATE yy/mm/dd <ENTER>. To set the date to June 1, 1997,
enter:
=>DATE 6/1/97 <ENTER>
6/1/97
=>
You can separate the month, day, and year parameters with spaces, commas, slashes, colons, and
semicolons.
EVE Command (Event Reports)
Use the Event command, EVE, to view event reports. See Section 12: Standard Event Reports
and SER for further details on retrieving event reports.
GRO Command (Display Active Setting Group Number)
Use the Group command, GRO, to display the active settings group number. See the GRO n
command in Access Level B Commands that follows in this section and Multiple Setting Groups
in Section 7: Inputs, Outputs, Timers, and Other Control Logic for further details on settings
groups.