11-4 Additional Front-Panel Interface Details Date Code 990215
SEL-351P Manual Técnico
Figure SECTION 11: .3: Local Control Switch Configured as an
ON/OFF/MOMENTARY Switch
Local control switches are created by making corresponding switch position label settings.
These text label settings are set with the SET T command or viewed with the SHO T command
via the serial port [see Section 9: Setting the SEL-351P Recloser Control and SHO Command
(Show/View Settings) in Section 10: Serial Port Communications and Commands]. See Local
Control Switches in Section 7: Inputs, Outputs, Timers, and Other Control Logic for more
information on local control.
View Extra Local Control (with factory settings)
Access extra local control via the CNTRL pushbutton. If local control switches exist (i.e.,
corresponding switch position label settings were made), the following message displays with the
rotating default display messages.
Press CNTRL for
Extra Control
Press the CNTRL pushbutton, and the first set local control switch displays (shown here with
example settings):
MANUAL TRIP ←→
Position: RETURN
Press the right arrow pushbutton, and scroll to the next set local control switch:
MANUAL CLOSE←→
Position: RETURN
To Next Page
Loading...