SEW-Eurodrive MOVIPRO Ethernet/IP - 13.3.3 Startup IPOSPLUS application modules

13
Parameter setting
Parameterizing the power section "PFA-..."
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
173
Carrying out partial startup
During a partial startup, you specify the following settings:
• Nominal motor voltage
• Rated motor frequency
• Rated line voltage
• Error response
• Temperature sensor type
• Download values of the drive parameters
Optimizing a speed controller
During an optimization of the speed controller, you change the download values of the
drive parameters.
13.3.3 Startup IPOS
PLUS®
application modules
The following application modules are available for the power section "PFA-...":
• Bus positioning
• Extended positioning via bus
• Modulo positioning
• Automotive AMA0801
INFORMATION
In MOVIPRO
®
ADC, the IPOS
PLUS®
application modules can only be used if a simple
gateway program is installed (delivery state) in the communication and control
unit"PFH-...," or the "Transparent6PD" CCU application module is parameterized. In
these cases, the process input and process output data is forwarded from the com-
munication and control unit to the power section "PFA-..." unmodified.
Information on how to operate the application modules is contained in separate manu-
als. They can be downloaded in PDF format from the SEW‑EURODRIVE website →
www.sew‑eurodrive.com.
The following manuals include startup of the IPOS
PLUS®
application modules:
• MOVIDRIVE
®
drive inverter bus positioning
• MOVIDRIVE
®
MDX61B application "Extended positioning via bus"
• MOVIDRIVE
®
MDX60B / 61B application "Modulo positioning"
• MOVIDRIVE
®
MDX61B and MOVIPRO
®
SDC/ADC application module "Automot-
ive AMA0801"
16998413/EN – 12/2016