SEW-Eurodrive MOVIPRO Ethernet/IP - Page 204

13
Parameter setting
Parameter descriptions
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
204
In operating modes "V/f" and "VFC & Group": Manual adjustment of the parameter is
required in order to increase the starting torque by raising the output voltage in the
range below the base speed.
In operating mode "VFC ": Manual adjustment of the parameter is normally not re-
quired. In exceptional cases, manual setting may be necessary to increase the break-
away torque. In this case, set max. 10%.
The following figure shows the phase-zero phase-to-phase voltage (not the voltage
difference between the outer conductors).
100% Boost
0% Boost
50V
n
Eck
U
A
U
Ama x
VFC
n
[3]
[1]
[2]
36028797297140363
[1] n
Slip
[2] 2xn
Slip
[3] Boost setting range
16998413/EN – 12/2016