SEW-Eurodrive MOVIPRO Ethernet/IP - Page 38

5
Installation notes
Connection to the Ethernet network
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
38
Status LED S2
Status LED Possible cause Measure
Flashing
green
The firmware of the communica-
tion and control unit is running
correctly.
–
Flashing
green/orange
Data backup is created/restored. –
Lights up or-
ange
Boot is active. –
Flashing or-
ange
• Firmware is being updated or
• Bootloader update required.
–
Flashes red
• SD memory card is not inser-
ted.
• File system on the SD
memory card is corrupt.
• Boot process has failed.
Switch the device off and back on
again. Contact
SEW‑EURODRIVE service if the
error reoccurs.
Status LED S3
Status LED Possible cause Measure
Lit green User program is running. –
Flashing
green
• Program sequence has
stopped.
• Bootloader update required.
Start the user program.
Off No program is loaded. Load an user program into the
communication and control unit.
16998413/EN – 12/2016