SEW-Eurodrive MOVIPRO Ethernet/IP - Page 49

6
Configuration and startup of EtherNet/IP™
Project planning examples
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
49
16760603787
6. Save the project and transfer it to the PLC.
7. Switch to RUN mode of the PLC.
18014400477830667
8. Check if the process data correspond to the values that are displayed in the para-
meter tree of the MOVITOOLS
®
MotionStudio engineering software or in the field-
bus monitor of the respective application module.
16998413/EN – 12/2016