Shimadzu TXB2201L - Page 109

BEFORE
WEIGHING
MAINTENANCE
TROUBLESHOOTING
FOR YOUR
INFORMATION
USING THE
BALANCE
USING MORE CONVENIENTLY
109
Continued on next page

3
Change the setting.
Pressing alternately sets the ON and OFF
settings.
[SET]
If OFF is selected, perform step 6. Steps 7
onward are not necessary in this case.
4
Set whether starting and ending of
the continuous output is
performed manually by key
operation.
[MANU]
Pressing alternately sets the ON and OFF
settings.
[SET]
5
Set whether the non-averaged
value is output as a continuous
output value.
[MANU] [NO.FIL]
Pressing alternately sets the ON and OFF
settings.
[SET]
! !S!E!T! !
!S!E!Q.P!R!N
When ON is set the stability mark is lit.
! !S!E!T! !
!S!E!Q.P!R!N
When ON is set the stability mark is lit.
! !M!A!N!U! ! !M!A!N!U!
! !S!E!T! !
! !M!A!N!U!
When ON is set the stability mark is lit.
! !S!E!T! !
! !M!A!N!U!
When ON is set the stability mark is lit.
! !N!O!.!F!I!L ! !N!O!.!F!I!L
! !S!E!T! !
! !N!O!.!F!I!L
When ON is set the stability mark is lit.
! !S!E!T! !
! !N!O!.!F!I!L
When ON is set the stability mark is lit.