SICK DL100 Pro - Page 69

8024484/2019-06-06 • © SICK AG • Subject to change without notice 69
Operation via Ethernet (Ethernet interface)
“SettingMF2function”eld Requirement for display
• “MF2 activation” parameter: “On” option
Parameters Description
Function Select function for MF2 multifunctional output.
Read/write access
• Read and write
Input value
• 0: Distance / 1: Speed / 2: Service
Factory setting
• Servicing
Active state Select level for the active state for MF2 multifunctional output.
Read/write access
• Read and write
Input value
• 0: high / 1: low
Factory setting
• low
Table 45: “Parameter settings” page – “Setting MF2 functions” eld
“MF2, distance undercut switching
threshold”eld
→ See Page 67, Table 42 “MF1, distance undercut switching threshold”.
“MF2, speed undercut switching
threshold”eld
→ See Page 68, Table 43 “MF1, speed undercut switching threshold”
eld.
“MF2,devicemonitoringcongura-
tion”eld
→ See Page 68, Table 44 “MF1, device monitoring”.
“MFactivationnumber”eld
Parameters Description
MF1 Counts the switching events of the MF1 multifunctional input
and output. You can reset the counter using the “Reset MF1”
button.
Read/write access
• Read and write
Input value
• –2147483648 ... 2147483647
M2 Counts the switching events of the MF2 multifunctional out-
put. You can reset the counter using the “Reset MF2” button.
Read/write access
• Read and write
Input value
• –2147483648 ... 2147483647
Table 46: “Parameter settings” page – “MF1 activation number” eld