SICK FLOWSIC100 Flare-XT - Page 184

184 FLOWSIC100 Flare-XT · Operating Instructions · 8023761/V 1-0/2020-10 · © SICK Engineering GmbH
Annex
Fig. 117 Control Drawings FLSE-XT (page 5 of 5)
Date
Created
Date
Released
FLARE-XT CONTROL DRAWING
2020-09-23
scheisv
2020-09-28
scheisv
FLARE-XT CONTROL DRAWING
Type:
Ident No: E288088
Rev.
Date
Name
D-01458 Ottendorf-Okrilla
Repl. for:
Repl. by:
Sh. 5 / 5
?
04
FLOWSIC100-XT-P
Class I, Division 1, Groups B, C and D, T4 Class I, Zone 1, Ex/AEx d[ia] IIB + H2, T4 Class I, Division 2, Groups A, B, C and D, T4 Class I, Zone 2, Ex/AEx nA[ia] IIC, T4
Power Supply: Terminals +24 V, GND 15…28 VDC, max. 500 mA Data Interface: Terminals RS485a, RS485b ±5 V, max. 500 mA Install device in accordance with NEC (ANSI/NFPA 70 ) in USA or CEC Part 1 in Canada. “[Ex ia]” WARNING: Substitution of components may impair intrinsic safety. AVERTISSEMENT: La substitution de composants peut nuire à la sécurité intrinsèque. Maximum non-hazardous voltage not to exceed 125 V. La tension maximale non dangereuse ne doit pas dépasser 125 V
Flameproof field wiring
Connecting Diagram Installation Diagram
Flameproof field wiring
Zone separating wall e. g. pip
e
line or duct