Operating instructions Chapter 1
S300
8010948/YY96/2016-02-17 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 7
Subject to change without notice
About this document
1 About this document
P
lease read this chapter carefully before working with this documentation and the S300.
1.1 Function of this document
These operating instructions are designed to address the technical personnel of the
machine manufacturer or the machine operator in regards to correct mounting, electrical
installation, commissioning, operation and maintenance of the S300 safety laser scanner.
These operating instructions do not provide instructions for operating the machine, the
system or the vehicle on which the safety laser scanner is, or will be, integrated. Informa-
tion on this is to be found in the appropriate operating instructions for the machine, the
system or the vehicle.
1.2 Target group
These operating instructions are addressed to planning engineers, machine designers and
the operators of machines and systems which are to be protected by one or several S300
safety laser scanners. They also address people who integrate the S300 into a machine, a
system or a vehicle, initialize its use, or who are in charge of servicing and maintaining the
device.
1.3 Scope
These operating instructions are original operating instructions.
These operating instructions are only applicable to the S300 safety laser scanner with one
of the following entries on the type label in the field Operating Instructions:
8010946 AE W284
8010946 AE X175
8010946 AE XK33
8010946 AE YY96
This document is part of SICK part number 8010946 (operating instructions “S300 —
Safety laser scanner” in all available languages).
For the configuration and diagnostics of these devices you require a CDS (Configuration &
Diagnostic Software) version M 3.6.7. To determine the version of your software version,
select the Module-Info... option in the ? menu.
To Next Page
Loading...
Need help?
General
