System
8.1 "System" operating area
Surface grinding
112 Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
$/$50
6<67(0
6HW
SDVVZRUG
Operating sequence
The full CNC keyboard is used to change to the <SHIFT> and <SYSTEM> operating areas
and the start screen is displayed.
Figure 8-2 Main screen, <SYSTEM> operating area
Softkeys
The start screen vertical softkeys are described below.
"Set password"
Three password levels are distinguished in the control system, which provide different
access rights:
● System password
● Manufacturer password
● User password
It is possible to change certain data corresponding to the access levels. If you do not know
the password, access will be denied.
Note
Also see SINUMERIK 802D sl "Lists".
To Next Page
Loading...
Need help?
General
