System
8.3 SYSTEM - "Machine data" softkeys
Surface grinding
116 Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
2.
0DFKLQH
GDWD
Select the desired mode using the cursor.
● Normal power-up
The system is restarted
● Power-up with default data
The system restarts with default values (restores the initial state when originally supplied)
Use "OK" to RESET the control system and to carry out a restart in the mode selected.
Use the <RECALL> key to return to the system start screen without performing any action.
8.3 SYSTEM - "Machine data" softkeys
References
You will find a description of the machine data in the following manufacturers´ documents:
SINUMERIK 802D sl List Manual
SINUMERIK 802D sl Function Manual for turning, milling, nibbling
Machine data
Any changes in the machine data have a substantial influence on the machine.
Figure 8-6 Structure of a machine data line
Table 8- 1 Legend
No. Significance
1 MD number
2 Name
3 Value
4 Unit
so immediately effective
cf with confirmation
re Reset
5 Effective
po Power on
To Next Page
Loading...
