System
8.4 SYSTEM - "Service display"
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
139
'DWH
7LPH
'D\OLJKW
VDYLQJWLPH
8.4.6 Date, time
Dialog box for setting the date and time of the control.
Figure 8-34 Dialog box "Date and time"
Input options in the dialog window "Date and time"
● Setting the time
Enter the time in the "time" fields. You can select whether the time is shown in the 24
hours or 12h format.
● Setting the date
In the fields under "Date" select the display format and enter the date.
● Using the time zones
Set the check mark in the field " Used time zones", and select the country-specific time
zone.
Changing the clock to daylight saving time.
To Next Page
Loading...
