Siemens SINUMERIK 802D sl - Linear Interpolation with Feedrate: G1

Programming
10.3 Axis movements
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
227
10.3.2 Linear interpolation with feedrate: G1
Functionality
The tool moves from the starting point to the end point along a straight path. The path
velocity is determined by the programmed F word.
All axes can be traversed simultaneously.
G1 remains active until canceled by another instruction from this G group (G0, G2, G3, ...).
Programming
G1 X... Y... Z... F... ; Cartesian coordinates
G1 AP=... RP=... F... ; Polar coordinates
G1 AP=... RP=... Z... F... ; cylindrical coordinates (3dimensional)
Note
Another option for linear programming is available with the angle specification ANG=... (see
Section "Blueprint programming").
)%
;

;


<

<
;
**<
;
*<)
;)
*<
0
Figure 10-14 Linear interpolation in three axes using the example of a slot