Part programming
7.3 Editing part programs or text files
Surface grinding
90 Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
7.3 Editing part programs or text files
Functionality
A part program or sections of a part program in the NC memory can only be edited if they
are currently not being executed.
Any modifications to the part program are stored immediately.
With the Editor, it is also possible to edit/process part programs and text files (*.ini etc.) on
other drives ("Customer CF card", "USB drive", (see main screen "Program Manager")). In
this case, the channel status of the control system does not play a role. The changes are
only saved when you close the program editor. Saving can be interrupted via a dialog.
Figure 7-4 Program editor start screen
To Next Page
Loading...
Need help?
General
