Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
359
Glossary
Effective wheel width
Wheel width of the inclined grinding wheel which is used to machine the diameter. It is
dependent upon:
● the physical width
● the evading height
● the angle of the wheel
Evasion/evasion angle
Tapering of the left or right side of the grinding wheel for face-grinding operations in which a
so-called cross-grinding is produced.
GAP/structure-borne noise/air grinding
Bridging the air gap between the workpiece and grinding wheel with a structure-borne noise
microphone, which is built into the machine.
GWPS
Grinding wheel peripheral speed in m/s
MCPA
Input card for rapid I/O to the control system
MD
Machine data; machine data are predefined variables (system variables), with which the
NCK, as per the requirements of the machine manufacturer, is adapted to the machine-tool.
SD
Setting data are system variables that indicate the current machine properties to the NCK.
Unlike machine data, changes to setting data always become effective immediately.
Seat
Machining operation
To Next Page
Loading...
