Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
301
Network operation
11
Introduction
The SINUMERIK 802D sl control system communicates via an RS-232 or network interface
with the PG/PC.
Prerequisites
The RCS802 tool must have been installed on the PC.
Note
The RCS802 tool is part of the toolbox of the SINUMERIK 802D sl and is supplied on a CD.
Ethernet connections
Thanks to the integrated network adapter, the control system is network-capable. The
following connections are possible:
● Peer-to-peer Ethernet: Direct connection between control system and PC using a cross-
over cable
● Ethernet network: Integrating the control system into an existing Ethernet network using a
patch cable.
Note
The Ethernet network function is only available for SINUMERIK 802D sl pro.
Screened network operation with encrypted data transfer is possible using a SINUMERIK
802D sl specific data transfer protocol. This protocol is used, e.g. for transmitting and
executing part programs in conjunction with the RCS tool.
To Next Page
Loading...
