Siemens SINUMERIK 802D sl - 4.6 Manual grinding

Setup
4.6 Manual grinding
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
45
6WDUW
SURI

%DFN
0DQXDO
JULQG
In the cycle, the shaper allowance is machined first and then all dressing strokes are
executed. The current state is shown in the fields.
The procedure can be aborted at any time.
To restart it, press the <Start prof.> softkey. Values can be modified.
Exit the "Profiling" function.
4.6 Manual grinding
Functionality
This function is for grinding (precision grinding) with the handwheel. This function does not
require a workpiece program.
Operation
Manual grinding is done in "Jog" mode.
The input screen is opened.
Entry of parameters into the input screen for manual grinding (see figure below):
● T or D number
● Select oscillating motion via toggle field.
The following oscillating motions are possible:
– No function
– Infeed Y axis no oscillation
– Infeed Z axis no oscillation
– Infeed Y axis oscillation X axis
– Infeed Z axis oscillation X axis
– Infeed Y axis oscillation X/Z axis
● Peripheral speed of tool (m/s)
● Workpiece speed (rpm)