System
8.4 SYSTEM - "Service display"
Surface grinding
132 Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
2SWLRQV
1&.UHVHW
SR
6HUYLFH
06*
Setting the licensed options.
Figure 8-28 Options
References
SINUMERIK 802D sl Operating Instructions for Turning, Milling, Grinding, Nibbling; Licensing
in SINUMERIK 802D sl
Executes a warm restart at the control.
8.4.5 Service MSG
The "Service MSG" function allows message texts/messages to be output via the following
interfaces:
● Output via the RS-232-C as data stream without protocol
● Output in a file
Message texts/messages include:
● Alarms
● Texts of MSG commands
To Next Page
Loading...
