Siemens SINUMERIK 802D sl User Manual

Automatic mode
6.8 Repositioning after interruption
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
81
&XVWRPHU
&)FDUG
5&6
FRQQHFW
0DQXIDF
WXUHUGULYH
86%
GULYH
6.8 Repositioning after interruption
After interrupting the program (<NC STOP>), you can retract the tool from the contour in
manual mode (JOG). The control saves the coordinates of the point of interruption. The
distances traversed are displayed.
Operating sequence
Select <AUTOMATIC> mode.
Press <NC START> to continue machining.
CAUTION
When reapproaching the interruption point, all axes will traverse at the same time. Make
sure that the traversing area is not obstructed.
6.9 Execute from external
Functionality
In <AUTOMATIC> mode > <PROGRAM MANAGER> operating area, the following
interfaces are available for external execution of programs:
Customer CompactFlash card
RCS connection for external execution via network (only for SINUMERIK 802D sl pro)
Manufacturer's drive
USB FlashDrive

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English