Cycles
9.4 Zyklenunterstützung im Programmeditor
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
163
9.4 Zyklenunterstützung im Programmeditor
The program editor provides programming support for adding cycle calls to the program and
for entering parameters.
Function
The cycle support offers the following functions:
● Cycle selection via soft keys
● Input screen forms for parameter assignment with help displays
Decompilable program code is generated from the individual screens.
Summary of required files
The following files constitute the basis for cycle support:
● sc.com
● cov.com
Note
These files are loaded during the start-up of the control system and must always remain
loaded.
Operating the cycle support
([HFXWH
)LQG
0DFKLQLQJ
*ULQGLQJ
F\FOHV
6HW
UHFRPSLOH
6HOHFWEORFN
&RS\EORFN
$GGEORFN
'HOHWHEORFN
1XPEHU
*:36WRRO
6DIHW\
KHLJKW
=SRVLWLRQ
ZLWKZKHHO
'UHVVLQJ
*ULQGLQJ
%DFN
'UHVVLQJ
SDWK
'UHVVLQJ
UROOHU
QGOHYHO
QGOHYHO
%DFN
3OXQJHFXWWLQJ
5HFLSURFDWLRQ
6XUIDFH
FRQWL
3URILOH
JULQGLQJ
6XUIDFH
LQWHUP
3OXQJHFXWWLQJ
VWDJH
6XUIDFH
VWDJHG
Figure 9-3 Menu tree for cycle support
To Next Page
Loading...
Need help?
General
