Siemens SINUMERIK 802D sl User Manual

Programming
10.14 Oscillation
Surface grinding
300 Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Several options are appended with plus characters.
Example:
The oscillating motion for the Z axis should stop at the reversal point 1 when switched off.
Where
● an end position is approached,
● a changed feed acts immediately and should immediately stop the axis after the deletion
of distance-to-go.
OSCTRL[Z] = (1+4,16+32+64)

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English