System
8.5 SYSTEM - "PLC" softkeys
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
143
2SHUDQG
2SHUDQG
'HOHWH
&KDQJH
6WDWXV
OLVW
Format B
H
D
Binary
Hexadecimal
Decimal
The binary representation is not possible with double words. Counters and timers
are represented decimally.
Figure 8-38 PLC status display
The operand address displays the value incremented by 1.
The operand address displays the value respectively decremented by 1.
Use this softkey to delete all operands.
Cyclic updating of the values is interrupted. Then you can change the values of the
operands.
Use the "Status list" function to display and modify PLC signals.
There are 3 lists to choose from:
● Inputs (default setting) left-hand list
● Flags (default setting) center list
● Outputs (default setting) right-hand list
● Variable
To Next Page
Loading...
Need help?
General
