Cycles
9.14 Dressing with profile roller - CYCLE430
Surface grinding
190 Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Sketch of the geometry parameters
Figure 9-13 Dressing with profile roller - CYCLE430
Programming example
Machining sequence:
● 2-stroke dressing with a dressing amount of 0.02 mm and 2 sparking-out revolutions
every 5 workpieces.
● The number of idle strokes is stored in the tool data, along with the peripheral speed
ratios of the spindles.
N10 T1D1
N20 CYCLE430(0.02,20,0.2,2,2,35,5)
N30 M30
To Next Page
Loading...
