Siemens SINUMERIK 802D sl - Page 309

Network operation
11.7 Establishing a peer-to-peer Ethernet connection to the control
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
309
3HHUWR
SHHU
3HHUWR
SHHU
Figure 11-8 "Network configuration" main screen
Press the "Peer-to-peer" softkey.
Figure 11-9 "Peer-to-peer"
The following message is shown on the HMI:
"Connection is set up"
● IP Address: 169.254.11.22
● Subnet mask: 255.255.0.0
Note
The IP address and subnet mask shown are fixed values.
These values cannot be changed.
Using the "Peer-to-peer" softkey you can cancel the Ethernet peer-to-peer connection.