PLC diagnostics
13.3 Operating options
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
327
3/&
LQIR
Keystroke combination Action
The function of the Select key depends on the position of the input
focus.
• Table line: Displays the complete text line
• Network title: Displays the network comment
• Command: Displays the complete operands
If the input focus is positioned on a command, all operands
including the comments are displayed.
Softkeys
The following PLC properties are shown with this softkey:
● Mode
● Name of the PLC project
● PLC system version
● Cycle time
● Machining time of the PLC user program
Figure 13-2 PLC info
By pressing the "Reset machining time" softkey, machining time data is reset.
To Next Page
Loading...
