6.3.3 Editing a new NC program.....................................................................................6-51
6.3.4 Program input with operator support......................................................................6-53
6.3.5 Machining cycles....................................................................................................6-55
6.3.6 Plane ............................................................................................................6-55
6.3.7 Program management ...........................................................................................6-56
6.3.7.1 Changing the access rights.................................................................................6-56
6.3.7.2 Copy program .....................................................................................................6-58
6.3.7.3 Rename program................................................................................................6-60
6.3.7.4 Delete program ...................................................................................................6-60
6.3.8 Move cycles ...........................................................................................................6-62
7 Services........................................................................................................................7-1
7.1 Selecting Parameter Assignment V24 ........................................................................7-2
7.2 Description of parameters...........................................................................................7-3
8 Diagnosis .....................................................................................................................8-1
8.1 Selecting Diagnosis area ............................................................................................8-2
8.2 Alarm and message displays......................................................................................8-4
8.2.1 Alarm groups............................................................................................................8-7
8.2.2 Alarm numbers/clearing alarms ...............................................................................8-8
8.2.3 Display of the alarms and messages in the alarm and message lines.....................8-9
8.2.4 On-line help for alarms and messages ..................................................................8-11
8.3 PLC Status................................................................................................................8-12
8.4 NC Service................................................................................................................8-12
8.5 Password ..................................................................................................................8-14
9 Information...................................................................................................................9-1
9.1 Selection of Information area......................................................................................9-2
9.2 NC Information............................................................................................................9-3
9.3 MMC Information.........................................................................................................9-4
9.4 Information = Logbook................................................................................................9-5
10 Exit ........................................................................................................................10-1
11 Maintenance.............................................................................................................11-1
11.1 Operating data ........................................................................................................11-2
11.2 Replacing the battery..............................................................................................11-3
11.3 Handling modules ...................................................................................................11-5
11.4 Practical tips on remedying electromagnetic compatibility problems......................11-7
11.5 Cleaning..................................................................................................................11-9
12 Abbreviations / Glossary........................................................................................12-1
12.1 Abbreviations ..........................................................................................................12-1
12.2 Glossary..................................................................................................................12-4
To Next Page
Loading...
