Siemens SINUMERIK 840C

To Next Page

To Previous Page

SINUMERIK 840C, OEM Version for Windows (BA)

5-1

Parameters

5.1 Selecting the parameter area......................................................................................5-2

5.2 Editing data in the PARAMETER area........................................................................5-4

5.2.1 Selecting data ..........................................................................................................5-5

5.2.2 Entering and correcting data....................................................................................5-6

5.2.3 Entering PLC data in ASCII format ..........................................................................5-7

5.3 Program parameters...................................................................................................5-8

5.3.1 Tool offsets ..............................................................................................................5-8

5.3.2 Zero offset ............................................................................................................5-11

5.3.3 Angle of rotation (coordinate rotation)....................................................................5-14

5.3.4 R parameters .........................................................................................................5-14

5.3.5 Plane ............................................................................................................5-17

5.3.6 Setting data...................................................................................................................

5.3.6.1 Working area limitation........................................................................................5-18

5.3.6.2 General setting data............................................................................................5-18

5.3.6.3 Spindle setting data.............................................................................................5-19

5.3.6.4 Scale...................................................................................................................5-20

5.3.6.5 General setting data bits (from SW 6.3 and higher behind setting bits)..............5-20

5.3.6.6 Axial setting data bits..........................................................................................5-21

5.3.6.7 Additive protection zone adjustment via setting data (from SW 6.3 and

higher) .............................................................................................................5-21

5.3.6.8 Position measuring signals .................................................................................5-23

5.3.6.9 Cycle setting data................................................................................................5-24

5.3.6.10 Axis and spindle converter (option)...................................................................5-25

5.3.6.11 Gearbox interpolation........................................................................................5-26

5.3.6.12 Travel to fixed stop............................................................................................5-31

Siemens SINUMERIK 840C - Parameters