EasyManuals Logo

Siemens SINUMERIK 840C Operator's Guide

Siemens SINUMERIK 840C
301 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #223 background imageLoading...
Page #223 background image
01.99 6 Programming
6FC5198-6AA60-0BP1 © Siemens AG 1999 All Rights Reserved
6-38 SINUMERIK 840C, OEM Version for Windows (BA)
INPUT key. Identical to the <ENTER> key on the MF2 keyboard. In the
editor, the INPUT key is used to terminate a line.
In dialog boxes, the EDIT key can be used to switch from one input box to the
next. Identical to the <TABULATOR> key on the MF2 keyboard.
6.2.7.3 Editing text
You select a block of text by setting a start and end mark as follows:
Position the input cursor on the first character to be selected.
Choose Mark from the Edit menu.
Position the cursor on the last character to be selected.
Choose Mark from the Edit menu.
The selected text block is displayed inversely and can be edited using the
commands in the Edit menu.
When a block is selected, the menu items Delete Block and Copy Block,
which are normally "gray" (deactivated), are available for selection.
As the position of the start and end mark is of no importance, the start mark
may be set before the end mark in the text.
You can use the commands Copy and Paste to copy a section of text:
Select the section of text to be copied.
Choose Copy from the Edit menu. This command copies the text block
into the Windows Clipboard. The start and end marks of the block are
cleared.
Position the input cursor at the point where you want to insert the text.
Choose the Paste command from the Edit menu to insert the text at this
point.
Terminating a line
or
Enter
Moving within dialog
boxes
or
Tabulator
Marking text
Copying text

Table of Contents

Other manuals for Siemens SINUMERIK 840C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840C and is the answer not in the manual?

Siemens SINUMERIK 840C Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 840C
CategoryControl Unit
LanguageEnglish

Related product manuals