01.99 5 Parameters
© Siemens AG 1999 All Rights Reserved 6FC5198-6AA60-0BP1
SINUMERIK 840C, OEM Version for Windows (BA)
5-25
5.3.6.10 Axis and spindle converter (option)
Press the ETC key to extend the softkey menu bar. The AXIS/SPINDLE
CONVERTER softkey is displayed.
When you press this softkey, the input screenform for the axis/spindle
converter function is displayed.
Fig. 5-12 Axis/spindle converter
With this function you can convert axis and spindle addresses into other axis
and spindle addresses.
Place the cursor on the toggle field ’Axes no’. If the contents can be switched to
’yes’, the function can be used in this channel.
Machine manufacturer
This function must be released and activated by the machine manufacturer for
the channel affected (technology MD).
In addition, a release is required in the channel-specific SD 540*.0.
Machine manufacturer
The machine manufacturer can configure an input disable when the keyswitch
is in the "0" position.
Axis/spind
converter
To Next Page
Loading...
