1 Introduction - SINUMERIK 840C and its Operation 01.99
6FC5198-6AA60-0BP1 © Siemens AG 1999 All Rights Reserved
1-14 SINUMERIK 840C, OEM Version for Windows (BA)
1.8.4 CD-ROM access via PC link software (SW 6 and higher)
Data can be stored on an external PC by using the user interface "PC link".
In software version 6 and higher, it is possible to update the software via a PC
link. The software is delivered on a CD.
1. Install the PC link on the external PC by using the "install.bat" file.
2. Connect the control to the external PC by means of a parallel cable.
Note
The PC link connection required for the installation and start-up has not been
EMC tested as required for normal operation, and may therefore only be used
for servicing purposes (parallel transfer cable,
Order No. 6FX2 002-1AA02-1AD0).
3. The following installation procedure is described in the "readme.txt" file in
the root directory of the CD.
Note
Before initiating backup or restore on the external PC, you have to select the
correct menu item on the control (Backup or Restore).
Important
The menu options of the PC Link program on the external PC are activated on
the control depending on the type of selection (Backup, Restore, Install or
Free Data Transfer).
PC link
Installation
procedure
To Next Page
Loading...
Need help?
General
