To Next Page

To Previous Page

6 Programming 01.99

SINUMERIK 840C, OEM Version for Windows (BA)

6-15

6.2.3.2 Editing job lists

You can edit job lists and thereby adapt them to your requirements with the aid

of the integrated editor WEdit.

• Activate the Data Management window.

• Select the workpiece whose job list you want to edit in the left-hand single-

line box

• Position the selection bar on the file named "job" in the left-hand list box.

• Press the EDIT softkey in the menu bar of the data manager.

Fig. 6-8 Editing the standard job list

An operating guide is displayed in the job list with a complete list of the

instruction set. A job list can contain the following instructions in any order:

1. Clear files for NCK memory (CLEAR ...)

2. Load instructions (LOAD or LOADCYC ...)

3. Start preparation (SELECT ...)

4. Start of MMC applications (CALL...)

5. Comments

Each line contains exactly one instruction. The instructions are processed in the

order in which they appear in the job list.

The individual sections of the job list (CLEAR, LOAD etc.) begin with the

comments (...). These are followed by the actual command to which the

operator must add path and program names. For reasons of clarity, you should

only edit in these command lines.

Siemens SINUMERIK 840C Operator's Guide

Other manuals for Siemens SINUMERIK 840C