4 Machine 01.99
6FC5198-6AA60-0BP1 © Siemens AG 1999 All Rights Reserved
4-46 SINUMERIK 840C, OEM Version for Windows (BA)
Position the selection cursor on MDA and press the input key.
A list of possible MDA programs is displayed.
Now select the MDA program that you wish to copy and press the softkey
COPY.
Fig. 4-22 Copying MDA programs
Now place the cursor on the directory "MPF" (for the purposes of this
example). You can see how the selected directory is updated.
Now enter the program type and the program number, e.g. MPF 1234 and press
the softkey COPY.
The NC blocks of MDA 1 now become main program MPF 1234.
COPY is possible only within the directory NCK, e.g. from MDA to MPF.
To save the data on disk, it is best to use (in the NC editor area) the softkeys
EDIT/ETC/SAVE UNDER.
Saving of the currently selected program
with the SK: PRGORAM CORRECTION/SAVE ON DISK/
or PROGRAM CORRECTION/ETC/SAVE UNDER
is described in section "Saving programs".
Copy
Note:
Edit
Save
under
To Next Page
Loading...
Need help?
General
