4 Machine 01.99
6FC5198-6AA60-0BP1 © Siemens AG 1999 All Rights Reserved
4-50 SINUMERIK 840C, OEM Version for Windows (BA)
Now press the softkey SELECT PROG./JOB. The following dialog text is
displayed: "Load workpiece?"
If you press the softkey SELECT PROG./JOB again, all the workpiece data as
listed in the job list are loaded from the hard disk into the NCK memory.
The workpiece name and the part program (if defined in the job list) are
accepted in the selected channel in the program pointer.
Fig. 4-26 Workpiece selection 2
If a workpiece has been selected and a job list exists, the data manager and
current processing is displayed during data transfer.
You can use this softkey to abort workpiece data transfer from the hard disk to
the NCK memory.
Important
If workpiece data transfer is aborted, incomplete program parts might be left
in the NCK memory.
• If a workpiece does not have a job list or the standard job list and if several
or no main programs exist, no program is selected for processing and no
workpiece name is displayed in the "program pointer".
• Several workpieces, even those from other directories (not NCK!), can be
loaded into the NCK memory using the function SELECT WORKPIECE.
• Any files already existing in the NCK memory are overwritten without
warning.
Select
prog./job
Stop work-
piece sel.
Notes
To Next Page
Loading...
Need help?
General
