2 Operator Interface 01.99
6FC5198-6AA60-0BP1 © Siemens AG 1999 All Rights Reserved
2-22 SINUMERIK 840C, OEM Version for Windows (BA)
If you press the NC STOP key, processing of the current part program is
interrupted. All axis movements are brought to a controlled stop. The reactions
of the H and M functions in the case of NC STOP are configured by the
machine manufacturer. For more information refer to the machine
manufacturer’s documentation. The associated LED lights up.
Processing can then be continued by pressing NC START.
If you press the NC START key, the part program called is started at the
current block; the associated LED lights up. Processing of a part program
interrupted with NC STOP is continued at the point of interruption on pressing
NC START.
Caution
The axis positions programmed in the current block are approached with linear
interpolation after the "NC START" key has been activated. Collision danger!
NC Stop
NC Start
To Next Page
Loading...
Need help?
General
