Siemens SINUMERIK

Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
189
SKNCNEWTOOLED=6
; Create new cutting edges in NC
SKNCDELTOOLED=6
; Delete cutting edges in NC
SKNCDELTOOL=5
; Delete tools in NC
SKTRAFO=7
; Toggle transformed / not transformed view of edge data
SKCHECKACTIVATE=6
; D check and activation
SKMGBUFFER=7
; Display the buffer
SKMGFIND=7
; Softkey search and position
Positioning
SKMGLISTPOS=7
; Softkey next magazine
SKMGNEXT=7
; Create tools in NC
SKTLNEWTOOL=6
; Display 1_ToolList
SKTLLREPR1=7
; Selection of Display 2_ToolList
SKTLLREPR2=5
; Display 3_ToolList
SKTLLREPR3=5
; Location search, user-defined 1
SKFINDPL1=7
; Location search, user-defined 2
SKFINDPL2=7
; Location search, user-defined 3
SKFINDPL3=7
; Location search, user-defined 4
SKFINDPL4=7
; Location search
SKFINDPL=7
; Location search, tool loading list
SKFINDPLACE=7
; Allows softkey current location
SKACTPLACE=7
; Softkey tool data in status loaded tools
SKLDTOOLDAT=7
; Load a magazine configuration
SKCONFLOAD=4
; Display 1_ActList
SKACLREPR1=7
; Display 2_ActList