To Next Page

To Previous Page

Tool management

6.2 Settings in the configuration file

HMI Advanced (IM4)

Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0

227

; automatically to magazine list state Values "NoAuto<<"

; and "Auto<<".

; magazine "turret15" ($TC_MAP2) can be displayed by shortcut 3,

; you must use "<<" softkey explicitly to leave magazine select

; state.

; magazine "chain50" can be displayed by shortcut 1 and there is

; an automatic return to magazine list state after pressing this

; shortcut softkey. To specify softkey text, use section

; "[ShortcutSoftKeysForMagSelect]" in language dependent

; ini files patm_??.ini.

; chain10 = 1, Auto<<

; turret20 = 2, Auto<<

; turret10 = 3, Auto<<

; chain20 = 5, NoAuto<<

; turret15 = 4, NoAuto<<

6.2.3 Configuring the display of softkeys

Softkey texts for the lists

The displays stored behind softkeys 1 to 3 in the magazine and tool lists are defined in the

file paramtm.ini.

As the default setting when tool management is selected, the displays appear that have

been configured for [1_MagList] and [1_ToolList].

Siemens SINUMERIK Commissioning Manual

Other manuals for Siemens SINUMERIK