Siemens SINUMERIK Commissioning Manual

Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
235
; if the current cutting edge D=0.
ProgToolZeroDBitmap = paptd0.bmp
; Name of the bitmap for the programmed tool /DNo./DL,
; if the current DL=0.
ProgToolZeroDLBitmap = paptdl0.bmp
; File name of the bitmap for the current magazine location
ActPlaceBitmap = paap.bmp
[1_MagList]
; Columns in which highlighting (bitmaps) is to be
; displayed:
ShowActToolCol = 1
ShowProgToolCol=1
ShowActPlaceCol=1
6.2.5 Example: Customized settings for the machines
Configuring the tool management displays in the paramtm.ini file
The tool management operator interface can be customized with the file paramtm.ini:
● Modify the structure and layout of the lists.
● Apply specific default values.
● Protect or deactivate functions via access rights.
All the functions and possibilities for tool management are listed in the paramtm.txt file on
HMI Advanced.
At installation and start-up, the operator can decide which functions are required for a
specific machine. Values and to some extent also functions can be preset to allow for
convenient, user-friendly operation.
Examples
Example 1:
● The tool data is to be automatically deleted when unloaded (magazine list only).
● The tool list function is not used.
● The function tool catalog and cabinet is not used.
The parameters can be assigned as follows:
...
[TMMODES]
...
DELETE_TOOL_ON_UNLOAD=1 The tool data is automatically deleted
on unloading.
...
[ACESSLEVEL]

Siemens SINUMERIK Specifications

General

Brand	Siemens
Model	SINUMERIK
Category	Control Unit
Language	English