Programming
2.6 Methods
Expanding the user interface
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
2-67
Programming
Syntax: OUTPUT
(Identifier)
...
END_OUTPUT
Description: Outputs variables in the NC program.
Parameters: Identifier Name of OUTPUT method
Block numbers and skip identifiers
The OUTPUT block must not contain line numbers or skip identifiers if you wish to keep the
line numbers and hide markings directly set with active program support in the parts program
in case of recompilations.
Editor changes in the parts program produce the following response:
Condition Response
Number of blocks remains unchanged. Block numbers are retained.
Number of blocks is reduced. The highest block numbers are canceled.
Number of blocks is increased. New blocks are not numbered.
Example
OUTPUT(CODE1)
"CYCLE82(" Var1.val "," Var2.val "," Var3.val ","Var4.val "," Var5.val
"," Var6.val ")"
END_OUTPUT
2.6.7 PRESS
Description
The PRESS method is executed when the corresponding softkey is pressed.
Programming
Syntax: PRESS
(softkey)
...
END_PRESS
Identifiers: Pressing a softkey
To Next Page
Loading...
