Configure hotkeys and PLC keys
4.5 List of selectable states
Expanding the user interface
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
4-21
State Function
50 Optimization/test (V7.1 and later)
60 HMI
Custom operating area
See chapter "Custom operating area".
4.5.2 Selectable states in HMI Embedded sl
Overview
There are the following configuration options for the state in HMI Embedded sl:
A configuration: Maintains current state.
Configuration with 0: The basic state of an operating area is activated.
4.5.3 Selectable states in ShopMill on NCU
Machine Manual
Legend:
* If option available (display MD is set)
Custom screen These designated functions can be configured with the "Expanding the
Operator Interface" system.
If this type of configuration is available, it is activated. Otherwise, the
standard ShopMill screen will appear.
State Function
19 Main screen
2 T, S, M, etc.
30 Workpiece zero
5 Workpiece zero - set up edge
7 Workpiece zero – /user screen form
31 Workpiece zero – align edge/user screen form
32 Workpiece zero – spacing 2 edges/user screen form
33 Workpiece zero – rectangular edge
8 Workpiece zero – arbitrary edge/user screen form
34 Workpiece zero – rectangular pocket
9 Workpiece zero – 1 hole/user screen form
To Next Page
Loading...
Need help?
General
