List of the INI Files
A.11 IB.INI
HMI Advanced (IM4)
288 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
A.11 IB.INI
Overview
Softkey access in the "Startup" operating area can be set by entering the protection level.
● Enter the required protection level in section [ACCESSLEVEL].
● The operator languages are defined in Section [LANGUAGE].
Note
In the [HELP_EXTENSION] section, the HelpFileExtension parameter must be set to 0
(WinHelp) if you want old, OEM-specific help files with the extension *.hlp to be
displayed.
[ACCESSLEVEL]
RESET =2 ;NCK Reset (NCK Reset)
CHG_SCL_SYS=5 ;change scaling system (Dimension system
inch/metric)
MASCHDAT =4 ;Machine data (Machine data)
DRIVE_CFG=2 ;Drive configuration (Drive configuration)
BOOTFILE=2 ;Bootfile (Bootfile)
MOT_CTRL=2 ;Motor/valve selection (Motor/valve selection)
VIEW=2 ;User views +
display options
(User views + display
options)
NC_ADDR=2 ;NCK Address (NCK address)
SETUP_SWITCH=2 ;Start-up switch (Commissioning switch)
PLC_STATE=3 ;PLC state (PLC status)
PLC_DATE=3 ;PLC date (PLC date)
PLC-CHANGE=2 ;PLC status: Interlocked by manufacturer
;SK Change Value
;SK Reset Value)
;SK Commit Value
(Change)
(Undo change)
(Apply changes)
DRIVE_SERVO=2 ;Drives/Servo (Drives/servo)
SET_COL=3 ;Colors (Colors)
SYST_SETTINGS=4 ;System settings (System settings)
SET_LANG=2 ;Language (Languages).
SET_BTSS=2 ;Operator panel (Operator panel front)
OPTION=2 ;Options (Options)
EDIT=1 ;Editor (Editor)
DOS=1 ;DOS shell (DOS shell)
TOOL_MNG=3 ;Tool management (Tool management)
FILE=7 ;File functions (File functions)
PASSWD=3 ;Set/Delete password (Change/delete password)
CHG_PASSWD=7 ;SK "Password..." (Softkey "Password...")
CHANGE_LANG=7 ;Change language (Change language)
LICENSE=1 ;Set license (Set license + NCK Reset)
SET_OPTIONS=1 ;Set options (Change options + NCK Reset)
SHOW_LICENSE=4 ;Display license (Show license)
SET_PD=2 ;Logic drives (Logical drives)
To Next Page
Loading...
Need help?
General
