Programming help systems
1.2 Quick "ASCII" help
Online Help (HE1)
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
15
Technology
The following characters are defined for specifying the technology category:
"m" = Milling
"t" = Turning
"g" = Grinding
"s" = Nibbling
"p" = Punching
"a" = Display for all technologies
Note
Entries are separated by commas so as to enable them to be assigned to several
technologies and different topics.
Topic ID
The topic ID is used for assigning instructions of a particular topic to the topic definition and
for displaying these under the topic.
Integrating additional commands
If additional commands and a brief description are to be integrated in the help, these must be
incorporated using the syntax described above in file IfM_gr.com (any file name), which is
stored in directory Dh\CMA.dir\. If an additional help (extended "PDF" help) is to be called up
for these commands, the parameter
"Extended help"
must be edited as described in the
section below.
1.2.6 Parameterization of extended "PDF" help
Calling extended help
A special entry in the "Extended help" parameter of the instruction definition makes it
possible to call up an extended "PDF" help as an online help in addition to the quick help.
This may contain detailed information on the selected command, for example. The following
calls are possible:
• Editor help:
Jump directly to the help (PDF file) from the quick "ASCII" help for a term (command) in
the program editor.
• Cycle help:
Jump to the help (PDF file) from an input field of the cycle screen.
To Next Page
Loading...
Need help?
General
