Configure hotkeys and PLC keys
4.1 Introduction
Expanding the user interface
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
4-3
You can find more information about HK7 and HK8 in the chapter "Configuring <M> key and
<MENU SELECT> as HK7, HK8".
Note
Hotkeys 1 and 7 (<M> key) cannot be distinguished by the hardware on the OP 10S
("Position" labeling). Hot key 7 is always triggered when one of the keys is pressed. If HK1 is
configured, this event can only be triggered by an external (MF2) keyboard.
Hotkey assignment on the MF2 keyboard
Hotkey OP label Key on MF2
HK1 Position <SHIFT+F11>
HK2 Program <END> (NB)*
HK3 Offset <Page Down> (NB)*
HK4 Prg.Manager <Home> (NB)*
HK5
Alarm
<Page Up> (NB)*
HK6 Custom <SHIFT+F12> or Cursor Down (NB)*
HK7 M Machine <SHIFT+F10>
HK8 Menu Select <F10>
*) Key is located on numeric keypad: <NumLock> must be off.
4.1.2 Functions of the keys on delivery
Delivery condition
On delivery of the system, the assignment of hotkeys to functions is entered in the KEYS.INI
file.
With HMI Advanced, the file can exist in various directories:
● user
● oem
● add_on *)
● mmc0w32 *)
● mmc2 *)
● hmi_adv *)
*) These directories are reserved for Siemens.
The files are executed in the above sequence. Entries in the directory, which appears at the
beginning of the sequence will disable existing entries in directories, which appear later in
the sequence.
To Next Page
Loading...
Need help?
General
