Siemens SINUMERIK Commissioning Manual

HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
3
Table of contents
1 Introduction................................................................................................................................................ 7
1.1 State of the system when supplied ................................................................................................7
1.2 Booting...........................................................................................................................................8
1.2.1 Settings at the HMI ........................................................................................................................8
1.2.2 System settings............................................................................................................................10
1.2.3 Behavior of the keys for the PCU.................................................................................................12
1.3 Access levels concept..................................................................................................................13
1.4 Licensing (solution line only)........................................................................................................15
1.5 Limits of data management..........................................................................................................17
2 Configuring the HMI system..................................................................................................................... 19
2.1 Processing INI files ......................................................................................................................19
2.1.1 Terminate OEM commissioning...................................................................................................22
2.1.2 Activating the screensaver...........................................................................................................23
2.1.3 Configuring the prompt dialog box for the EXIT mode ................................................................23
2.1.4 Setting the storage location for the alarm log ..............................................................................24
2.1.5 Configuring the acknowledgement icon for PLC alarms..............................................................26
2.1.6 Changing access levels for programs..........................................................................................27
2.1.7 Configuring the '"Language Selection" softkey............................................................................28
2.1.8 Creating user operator menus .....................................................................................................29
2.1.9 Supplementing service displays on a user-specific basis............................................................36
2.1.10 Setting the Wide Display for OEM applications ...........................................................................39
2.1.11 Creating technology-specific texts ...............................................................................................42
2.1.12 Set-up workpieces with job lists...................................................................................................44
2.1.13 Tool management (WZV).............................................................................................................45
2.1.14 Tool selection without tool management .....................................................................................46
2.1.15 Executing from the hard disk (m:n configuration) ........................................................................48
2.2 Configuring a channel menu........................................................................................................51
2.2.1 Applications for the channel menu...............................................................................................51
2.2.2 Structure of the channel menu.....................................................................................................52
2.2.3 Configuration of a channel menu for direct channel selection (1:1 configuration).......................53
2.2.4 Configuring a double-channel display..........................................................................................56
2.2.5 Channel menu for control unit management for an m:n configuration (powerline)......................57
2.2.6 Channel menu for control unit management for an m:n configuration (solution line) ..................58
2.2.7 Management of operating units 1:N (solution line) ......................................................................63
2.3 Connecting network drives...........................................................................................................66
2.3.1 Setting up access to external drives or computers......................................................................66
2.3.2 Connecting Drives with Display Machine Data............................................................................66
2.3.3 Connecting logical drives .............................................................................................................68
2.4 Simulation ....................................................................................................................................73
2.4.1 Display of the simulation files.......................................................................................................73
2.4.2 Data match of the simulation .......................................................................................................74
2.4.3 Speeding up the simulation boot..................................................................................................78
2.4.4 Expanding geometrical tool data..................................................................................................79
2.4.5 Optimizing the memory requirement............................................................................................81

Siemens SINUMERIK Specifications

General

Brand	Siemens
Model	SINUMERIK
Category	Control Unit
Language	English