Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
186 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
6.2 Settings in the configuration file
6.2.1 Parameterize the paramtm.ini file
Configuration
Customized differences from the factory-set ini data are stored in the "user" or "oem"
directories. Only changes to the visual aspect of the operator interface are stored here, i.e.
changes that can be made by settings in the HMI operator interface itself.
All data that describes the operator interface of the tool manager are saved in the
...\user\paramtm.ini file. To edit the file, select "Start-up" → "HMI" → "Editor". The paramtm.ini
file can also be created on an external PC and copied into the ..\user directory.
Country-specific sections are parameterized in the "language\patm_xx.ini" file in the
[BatchTools] section. "xx" stands for the national identifier, e.g. gr for German, uk for English.
Other languages: see Table 2-2.
Additional functions
The following additional functions have been implemented in the magazine, tool, work
correction list and tool details:
● Parameter settings for bitmaps in the list
● Tool identifiers and duplo numbers can be changed in the lists
● New magazine list with several lines
● Job processing of tools
● Tool-status bit "Pre-warning limit" can be changed in displays of lists
● Tool status bit "Unload detection" and "Load detection" in displays of lists and details can
be changed
● New tool types:
550 Steel profile
700 Slotting saw
711 Edge probe
720 oriented probe
730 Stop
To Next Page
Loading...
Need help?
General
