Configuring the HMI system
2.1 Processing INI files
HMI Advanced (IM4)
46 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
- curMagNo Magazine number; "0", if the current tool
is not to be found in or intended for a tool location.
- curPlaceNo magazine location number; "0" if current tool
is not to be found in or intended for a tool location.
Current magazine in magazine list view:
- curMagLiMagNo magazine number,
Target magazine, target magazine place during loading, unloading, reloading, positioning,
empty place search:
- targetMagNo magazine number
- targetPlaceNo magazine place number
Source magazine, source magazine place during loading, unloading, reloading, positioning,
empty place search:
- sourceMagNo magazine number
- sourcePlaceNo magazine place number
Current tool in tool cabinet:
- curCabToolIdent tool identification
- curCabToolDuplo tool duplo number
- curCabToolType tool type
Current tool in tool catalog:
- curCatToolIdent tool identification
- curCatToolDuplo tool duplo number
- curCatToolType tool type
Additional information needed for commissioning can be found in:
References: Function Manual Tool Management
2.1.14 Tool selection without tool management
Function
The "Parameters without tool management" application provides local NCDDE variables that
write to the currently selected tool. The tool management functions are used for this purpose
for tool selection under Parameters. The reason why these variables are written is influenced
by the settings in PARAM.INI: Variables are written to only when images change as a result
of "Expand user interface" or, alternatively, at each parameter status change.
The tool is selected with the cursor in the tool images without tool management. When the
cursor is positioned on a tool, the internal T number and the edge number are written to local
NCDDE variables for this tool. These variables can be evaluated from "Expand user
interface."
All data in one variable
The name of the NCDDE variables follows the pattern:
"PAHMICurData"_< MMCName>, with MMCName from MMC.INI.
To Next Page
Loading...
Need help?
General
