Configuring the HMI system
2.1 Processing INI files
HMI Advanced (IM4)
42 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
2.1.11 Creating technology-specific texts
Function
The following sections are available in the IF.INI file for parameterizing the Help functions:
● TECHNOLOGY
● TEXTFILES
● CONTEXT
● TEXTSEARCH
Section [TECHNOLOGY]
The technology group to which the machine belongs can be specified in the
[TECHNOLOGY] section in order to limit the display of instruction texts to those entries that
are relevant for the machine. Then, only entries that are relevant to the technology group are
displayed.
The following technology codes can be specified:
"m" = Milling
"t" = Turning
"g" = Grinding
"s" = Nibbling
"p" = Punching
"a" = Display all technologies
Section [TEXTFILES]
The paths (path\name) of the Quick Help text files on which the help function is based are
parameterized in the [TEXTFILES] section.
The help function accesses the following text files:
● Siemens dh\cst.dir\ifs_gr.com
● Machine manufacturer dh\cst.dir\ifm_gr.com (any file name)
● End user dh\cst.dir\user_gr.com (any file name; is also entered under "Settings")
Note
The path for the Siemens text file "Dh\Cst.dir\Ifs_gr.com" must exist; if not, an error
message is output accordingly.
The entry for Siemens is specified in conjunction with ISO language as:
SiemensI=file
where file equals ifit_xx.com for turning or
where file equals ifim_xx.com for milling.
To Next Page
Loading...
Need help?
General
