Introduction
1.3 Access levels concept
HMI Advanced (IM4)
14 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Changing the password
Procedure:
1. Press the "Password" softkey.
2. Press the "Set password" softkey.
3. The input window is displayed "Please enter password"
4. Enter one of the three possible passwords and press the Enter key or icon to
acknowledge. A permissible password is acknowledged as set and the currently
applicable access level is displayed. Invalid passwords will be rejected. You must delete
the old password before activating a password for a lower access level than the one
activated.
5. Press the "Delete password" softkey.
6. After pressing the "Delete password" softkey the valid password is deleted and deletion is
acknowledged. The currently valid access level: Key-operated switch setting 0 is set.
7. If a password is already set, then you can change it as follows. Press the "Change
password" softkey. The "Change password" input box appears:
Figure 1-2 Changing the password
8. The modified password must be entered in both input fields then confirmed by pressing
the "OK" softkey. Both entered passwords must match for the modified password to
become valid.
To Next Page
Loading...
Need help?
General
