Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
196 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
; 2048=in (Load)
; 4096=Regular tool (permanent in NCK)
; 8192=
; 16384=
; Default is 4828 (4+8+16+64+128+512+4096),
; For code carrier 92 (4+8+16+64)
CABIB_TOOLSTATE_MASK=4828
SINCOM_TOOLSTATE_MASK=4828
CODECARRIER_TOOLSTATE_MASK=92
TOOLSEARCH_TC_TP10_FROM_DB=0
; Tool search:Processing $TC_TP10 in conjunction with the
; tool cabinet/catalog
; 0 = (Default) If a tool is moved from the tool cabinet into
; the NCK, the value "Spare tool no. ($TC_TP10)"
; is not transferred to the NCK.
; ($TC_TP10) is set in the NCK to 0.
; 1 = The value "Spare tool no. ($TC_TP10)" is transferred
; from the tool cabinet into the NCK and displayed in the
; tool catalog/tool cabinet screens.
[General]
; Settings for "Write current data for tool management
; HMI to NCDDE variables on changing to
; WIZARD screens or on pressing WIZARD softkeys":
; All settings must be set in one single line by the name
; parameter.
; An option is enabled by the value "True" and
; disabled by the value "False" or by the absence of the
; name parameter in the line.
; "EnableAllTogetherWriteToNcdde := True": all data in a single
; NCDDE variable
; "EnableSingleWriteToNcdde := True": each data item has a separate
; NCDDE variable
; Both settings can be simultaneously active.
; If neither option is active, the NCDDE variables are not
; written to.
; "WriteChangesWhenStateChanged := True": data is written when any
; softkey is activated, not just WIZARD softkeys.
HMICurDataInterface = EnableAllTogetherWriteToNcdde := True,
EnableSingleWriteToNcdde := True,
WriteChangesWhenStateChanged := False
; $MM_WRITE_TOA_FINE_LIMIT and $MM_USER_CLASS_WRITE_FINE are applied
; to the geometry values and basic values of cutting edge data
UseFineLimitForToolGeoAndAdapt=False ; (default)
;UseFineLimitForToolGeoAndAdapt=True
; 1: Read language-specific INI files (language\patm_xx.ini)
; (default)
To Next Page
Loading...
Need help?
General
